Husqvarna · Automower 320 NERA
No loop signal
If your Husqvarna Automower 320 NERA shows No loop signal, do not replace parts from the message alone. Start with the checks below to separate installation, obstruction, power, positioning and component faults where applicable.
Most likely causes
- Station power, low-voltage cable, boundary wire, connector, loop antenna or interference condition
Diagnostic checks in order
- Check station power/LED, low-voltage cable and boundary connectors; isolate wire faults before replacing electronics.
Retest after each meaningful change. If the mower returns to normal, stop changing variables and monitor the result.
Safety
- Stop the mower and follow the manufacturer shutdown/isolation procedure before touching blades, wheels, charging contacts or internal components.
Escalate procedures involving mains electricity, battery-pack disassembly, sealed electronics or proprietary service tooling.
Parts potentially involved
- No replacement part should be ordered until the fault is isolated; inspect model-specific components named in the diagnostic procedure.
Association is not diagnosis: confirm the failed path before ordering components.
Evidence
Grade B — Manufacturer/model-family evidence
Applicability: {'model': 'Automower 320 NERA', 'family': 'Automower/CEORA family; official Automower support/manual corroboration', 'scope': 'Manufacturer/product-family corroboration; exact menu names, limits and part numbers must be confirmed for this model.'}
Related Automower 320 NERA faults
Need the interactive diagnosis?
Continue through the model-aware MowerFixAI workflow and compare this fault with related symptoms.
Start diagnosis →