Segway Navimow · i208 LiDAR
Battery discharges while docked
If your Segway Navimow i208 LiDAR shows Battery discharges while docked, do not replace parts from the message alone. Start with the checks below to separate installation, obstruction, power, positioning and component faults where applicable.
Most likely causes
- Intermittent contact, station power loss or sleep/firmware condition
Diagnostic checks in order
- Confirm station power
- clean contacts
- check docking alignment
- record whether the app shows charging continuously.
Retest after each meaningful change. If the mower returns to normal, stop changing variables and monitor the result.
Safety
- Stop the mower and follow the manufacturer shutdown/isolation procedure before touching blades, wheels, charging contacts or internal components.
Escalate procedures involving mains electricity, battery-pack disassembly, sealed electronics or proprietary service tooling.
Parts potentially involved
- No replacement part should be ordered until the fault is isolated; inspect model-specific components named in the diagnostic procedure.
Association is not diagnosis: confirm the failed path before ordering components.
Evidence
Grade B — Manufacturer/model-family evidence
Applicability: {'model': 'i208 LiDAR', 'family': 'Navimow family; official model-family manual download centre', 'scope': 'Manufacturer/product-family corroboration; exact menu names, limits and part numbers must be confirmed for this model.'}
Need the interactive diagnosis?
Continue through the model-aware MowerFixAI workflow and compare this fault with related symptoms.
Start diagnosis →