Worx · Landroid S300 (WR130E)
Charging / docking error
If your Worx Landroid S300 (WR130E) shows Charging / docking error, do not replace parts from the message alone. Start with the checks below to separate installation, obstruction, power, positioning and component faults where applicable.
Most likely causes
- Contacts, base power, alignment or battery condition
Diagnostic checks in order
- Clean contacts, verify base power and docking alignment.
Retest after each meaningful change. If the mower returns to normal, stop changing variables and monitor the result.
Safety
- Stop the mower and follow the manufacturer shutdown/isolation procedure before touching blades, wheels, charging contacts or internal components.
- Do not open mains-powered adapters or charging-station electronics; dealer/electrician diagnosis is recommended for mains-side faults.
Escalate procedures involving mains electricity, battery-pack disassembly, sealed electronics or proprietary service tooling.
Parts potentially involved
- No replacement part should be ordered until the fault is isolated; inspect model-specific components named in the diagnostic procedure.
Association is not diagnosis: confirm the failed path before ordering components.
Evidence
Grade B — Manufacturer/model-family evidence
Applicability: {'model': 'Landroid S300 (WR130E)', 'family': 'Landroid Classic wire-guided family', 'scope': 'Manufacturer/product-family corroboration; exact menu names, limits and part numbers must be confirmed for this model.'}
Source: Worx manufacturer support/manual
Need the interactive diagnosis?
Continue through the model-aware MowerFixAI workflow and compare this fault with related symptoms.
Start diagnosis →