Flymo EasiLife 200: No loop signal

Use this diagnostic path to narrow the fault before buying parts. MowerFixAI is independent and does not claim manufacturer endorsement.

Error/code: No loop signal

Likely causes

Power supply, low-voltage cable or boundary-loop issue

Before replacing anything

Confirm the symptom is repeatable. Note whether it occurs at startup, during mowing, under cutting load, while returning to the dock, or only in one part of the lawn. Change one variable at a time and retest.

Step-by-step diagnostic procedure

Check station power, low-voltage cable and boundary-wire connections.

If the mower behaves normally after one step, stop there and monitor it before replacing parts.

Safety and escalation

Stop the mower and follow the manufacturer shutdown/isolation procedure before touching blades, wheels, charging contacts or internal components.

Stop if the next step requires mains-voltage work, opening sealed electronics, battery-pack disassembly or a proprietary service tool. Use an appropriately qualified dealer for those procedures.

Parts that may be involved

No replacement part should be ordered until the fault is isolated; inspect model-specific components named in the diagnostic procedure.

Do not order a part from the error message alone. A related component is not proof that the component has failed.

Evidence and model applicability

Grade B — Manufacturer/model-family evidence

{'model': 'EasiLife 200', 'family': 'Flymo EasiLife/UltraLife robotic mower family', 'scope': 'Manufacturer/product-family corroboration; exact menu names, limits and part numbers must be confirmed for this model.'}

Source: Flymo EasiLife operator documentation

If the fault is intermittent

Capture the exact message, LED state, battery percentage and mower location when it happens. Intermittent faults are often easier to isolate from the conditions surrounding the failure than from a restart after the event.

Run the complete model-aware diagnosis

Continue through MowerFixAI's interactive diagnostic workflow to compare this fault with related symptoms and next checks.

Start diagnosis →