Husqvarna Automower: Guide Wire Problem
Having this problem with your Husqvarna Automower? Start with the checks below before buying parts or resetting the mower.
First checks
- Check the charging-station indicator and confirm the loop/guide connectors are firmly seated.
- Inspect recent garden work, edging and joins for a damaged or disconnected cable.
- Test suspect connectors and splices before replacing mower electronics.
- If supported by your model, use a short temporary test loop to separate a lawn-wire fault from a mower/station fault.
Important: exact LED meanings, error codes and reset procedures can vary by model and firmware. Confirm your exact mower before replacing components.
What usually causes this type of problem?
Common fault areas include power or charging connections, installation/wiring, obstruction or contamination, positioning/connectivity, battery condition, or a model-specific sensor/motor fault. The exact order of checks depends on your mower model.
Continue with one guided diagnosis
MowerFixAI will carry this fault into the diagnosis, ask about your exact model and narrow down the likely cause before you buy parts or book a repair.
Start DiagnosisFull diagnostic access €4.99 once · Takes about 2 minutes