Husqvarna Automower 305 Charging station blocked — Charging Station Blocked: Fix & Checks

Check in this order

1. Remove obstacles, check that the station is level, clean charging contacts and inspect power/guide connections before escalating to service.
2. Record the exact code/message and where the mower stopped before clearing it.
3. Avoid ordering a battery, motor or board until simple installation, obstruction, power and connection checks have been ruled out.
4. If the same error returns on clear level ground after the supported checks, use an authorised service route.

Safety: Switch the mower off before cleaning wheels or the cutting system. Disconnect station power before handling exposed charging-station wiring. Never open or bypass a sealed lithium battery or safety system.

Why MowerFixAI does not jump straight to a replacement part

An error message identifies the system that detected a problem; it does not always identify the failed component. MowerFixAI uses the mower model, exact error, location and follow-up checks to separate installation, environment, charging, navigation and hardware causes before suggesting a part or dealer.

Symptoms that help narrow this fault

Common clues are repeated docking attempts, a mower that sits on the station without increasing battery percentage, intermittent charging, a station that appears dead, or a mower that charges only when manually repositioned.

Practical checks before replacing parts

1. Clean and visually inspect the mower and station charging contacts with power isolated.
2. Confirm the station power supply is live and note the station LED/status before changing parts.
3. Check that the mower sits squarely on the contacts and is not being held away by debris, uneven ground or a distorted station.
4. If charging starts and stops when the mower is moved slightly, investigate contact pressure, alignment and connections before buying a battery.
5. Where possible, compare battery voltage/status and charger behaviour with a known-good compatible component or dealer test.

When to stop DIY checks

Stop and use an authorised repair route if the mower has impact damage, water ingress, a swollen or damaged lithium battery, exposed wiring, repeated internal electronic faults, or if a test requires opening a sealed battery, power supply or safety system. Bring the exact error text and the checks you have already completed; that can shorten dealer diagnosis time.

Related next steps

Browse popular robotic mower fixes · See more model-specific error guides · Run MowerFixAI diagnosis

Frequently asked questions