Worx Vision M800 (WR208E) E5 — Landroid Lifted: Fix & Checks
Worx Vision M800 (WR208E) showing E5 (Landroid Lifted)? Check lift / tilt sensing causes in the right order, then continue into MowerFixAI diagnosis.
What to do first
Place the mower flat on clear ground. Check whether a wheel or body edge was raised by uneven ground or an obstacle.
Check in this order
- Place the mower flat on clear ground. Check whether a wheel or body edge was raised by uneven ground or an obstacle.
- Record the exact code/message and where the mower stopped before clearing it.
- Avoid ordering a battery, motor or board until simple installation, obstruction, power and connection checks have been ruled out.
- If the same error returns on clear level ground after the supported checks, use an authorised service route.
Safety: Switch the mower off before cleaning wheels or the cutting system. Disconnect station power before handling exposed charging-station wiring. Never open or bypass a sealed lithium battery or safety system.
Why MowerFixAI does not jump straight to a replacement part
An error message identifies the system that detected a problem; it does not always identify the failed component. MowerFixAI uses the mower model, exact error, location and follow-up checks to separate installation, environment, charging, navigation and hardware causes before suggesting a part or dealer.
Symptoms that help narrow this fault
Look for one wheel failing to turn, repeated pivoting, clicking or humming from a drive motor, the mower stopping on level ground, or the same side repeatedly reporting blocked or trapped.
Practical checks before replacing parts
- Switch the mower off and remove grass, string, twigs and packed debris around the affected wheel.
- With the mower safely powered down, compare how freely the left and right drive wheels rotate.
- Inspect the tyre and wheel hub for damage or something wedged behind the wheel.
- Test on clear, level ground to separate a mechanical fault from terrain or boundary behaviour.
- If the same side repeatedly fails after cleaning, record the exact message before considering a motor, gearbox or wiring repair.
What not to replace too quickly
Do not assume every “trapped” or wheel-motor message means a failed motor. Terrain, debris, a seized wheel bearing, damaged tyre or an installation issue can trigger the same symptom.
Run the model-specific diagnosis
Continue with the mower and error already identified so you do not have to start from a generic help page.
Diagnose this errorFind a nearby dealerCheck parts diagramsWhen to stop DIY checks
Stop and use an authorised repair route if the mower has impact damage, water ingress, a swollen or damaged lithium battery, exposed wiring, repeated internal electronic faults, or if a test requires opening a sealed battery, power supply or safety system. Bring the exact error text and the checks you have already completed; that can shorten dealer diagnosis time.
Related next steps
Browse popular robotic mower fixes · See more model-specific error guides · Run MowerFixAI diagnosis
Frequently asked questions
What does E5 mean on Worx Vision M800 (WR208E)?
It points to the lift / tilt sensing area. The code identifies the system that stopped operation, but the underlying cause still needs to be narrowed down.
Should I replace a part immediately?
No. Start with safe external checks and confirm the exact model and conditions. A code can be triggered by terrain, installation, obstruction or connection problems as well as a failed component.
What information should I save before resetting the mower?
Save the full error text, model, firmware/app version if available, mower position, station status and what the mower was doing immediately before the fault.
Verification source
This page uses original MowerFixAI troubleshooting text and is cross-checked against the manufacturer support source below. Always follow the safety and model-specific instructions supplied with your mower.