INSTALLATION GUIDE

STIGA A 3000 installation procedure

STIGA autonomous GNSS/virtual-boundary installation · STIGA.GO

Important: This is a MowerFixAI installation workflow, not a replacement for the product manual. Exact cable offsets, station clearances, slope limits, electrical requirements and positioning accessories vary by model/year. Follow the manufacturer manual where it differs.

Step-by-step installation

Step 1. Survey the lawn and confirm the model's positioning requirements, including sky view, Wi-Fi/cellular coverage and any RTK/reference-station requirements.
Step 2. Choose and install the charging station on suitable level ground with safe mains power and the clear approach required by the manufacturer.
Step 3. Install/configure the model's reference station, antenna or positioning service if required, then charge and pair the mower with the official app.
Step 4. Use the manufacturer's mapping workflow to create the work boundary; add no-go/stay-out zones, channels/paths and separate work areas as supported.
Step 5. Set cutting height, mowing schedule and positioning/network settings.
Step 6. Supervise initial mowing and docking runs, inspect difficult edges/trees/buildings for positioning issues, and refine the map using only supported app controls.

Before the first unattended mow

Confirm blades and underside are clear and guards/covers are fitted.
Verify charging and docking repeatedly.
Check boundaries/no-go zones beside roads, water, drops, steps and public areas.
Supervise the first full mowing cycle and correct any unsafe or unreliable area before normal operation.

Manufacturer/support starting point

Diagnose a mower problem