INSTALLATION GUIDE

Worx Landroid S300 (WR130E) installation procedure

Landroid boundary-wire installation · Worx Landroid app

Important: This is a MowerFixAI installation workflow, not a replacement for the product manual. Exact cable offsets, station clearances, slope limits, electrical requirements and positioning accessories vary by model/year. Follow the manufacturer manual where it differs.

Step-by-step installation

Step 1. Plan the charging base and continuous boundary-wire loop, including islands around protected obstacles.
Step 2. Install the base on a flat area with power and the straight approach specified in the model manual.
Step 3. Lay and secure the boundary wire around the lawn with the correct offsets and corners; return both ends to the base.
Step 4. Connect the loop to the base, power it, charge the mower and pair/configure the mower in the Landroid app where supported.
Step 5. Run an edge/boundary test before final burial or permanent fixing, then set schedule and cutting height.

Before the first unattended mow

Confirm blades and underside are clear and guards/covers are fitted.
Verify charging and docking repeatedly.
Check boundaries/no-go zones beside roads, water, drops, steps and public areas.
Supervise the first full mowing cycle and correct any unsafe or unreliable area before normal operation.

Manufacturer/support starting point

Diagnose a mower problem