INSTALLATION GUIDE

Worx Vision L1300 (WR213E) installation procedure

Landroid Vision camera-based wire-free setup · Worx Landroid app

Important: This is a MowerFixAI installation workflow, not a replacement for the product manual. Exact cable offsets, station clearances, slope limits, electrical requirements and positioning accessories vary by model/year. Follow the manufacturer manual where it differs.

Step-by-step installation

Step 1. Prepare the lawn edges and choose a flat charging-base location with a clear approach.
Step 2. Install/power the base, charge the Vision mower and pair it with the Worx/Landroid app.
Step 3. Follow the model's Vision setup so the camera can recognise lawn boundaries; install RFID/magnetic accessories only where the model instructions call for them, such as transitions or restricted areas.
Step 4. Walk/check difficult edges, passages and separate zones and adjust the physical lawn edge or supported accessories where recognition is unreliable.
Step 5. Set schedule/cutting height and supervise initial mowing and return-to-base runs.

Before the first unattended mow

Confirm blades and underside are clear and guards/covers are fitted.
Verify charging and docking repeatedly.
Check boundaries/no-go zones beside roads, water, drops, steps and public areas.
Supervise the first full mowing cycle and correct any unsafe or unreliable area before normal operation.

Manufacturer/support starting point

Diagnose a mower problem