Worx Landroid L2000 (WR155E): Wire Missing

What this fault means

Landroid cannot detect the boundary-wire signal.

Safety: Stop the mower and follow the manufacturer safety instructions before physical inspection.

Step-by-step checks

1. Remove Landroid from the base and note the charging-base LED.
2. If the LED is off, verify power to the charging base.
3. If the LED indicates a wire fault, inspect both boundary connections and known splices for a break/corrosion.
4. If a detector hears signal around the whole loop, temporarily test with a short known-good loop at the station to separate installation from mower/base electronics.
5. Press START to reset only after the signal fault has been corrected.

Evidence source: Manufacturer/support reference

Evidence checked 2026-08-25. Diagnostic procedures are labelled separately from manufacturer-exact error instructions.

Did one of these checks actually fix the mower?

Confirmed repair outcomes improve MowerFixAI for the next owner and help separate common symptoms from real component failures.