HUSQVARNA AUTOMOWER TROUBLESHOOTING
Husqvarna Automower “No Loop Signal”: Complete Troubleshooting Guide
Quick answer
If your Automower reports No loop signal, check the charging-station LED first. On a physical boundary-wire installation, a flashing blue LED means the station cannot establish a complete loop signal and commonly points to a broken wire or faulty connection. Do not start replacing mower electronics before checking the loop installation.
1. Read the charging-station LED
| LED | What it points to | Next check |
|---|---|---|
| Flashing blue | No complete loop signal detected. | Boundary-wire connectors, joints and a possible wire break. |
| Solid green | Charging station is operating normally. | If the mower still says No loop signal, continue with mower/loop-signal checks. |
| Flashing green | ECO mode is active. | Take the mower out of ECO mode correctly before assuming the loop is faulty. |
| Solid blue | Weak boundary-wire signal. | Inspect wire condition, loop length and station connections if operation is affected. |
| No light | No station indication. | Check socket power, power supply and low-voltage cable. |
2. Check the simple connection points first
- Switch off and isolate the mower before inspecting wiring.
- Check the boundary-wire connectors at the charging station are fully seated and not corroded or loose.
- Inspect recent cable joints and any areas disturbed by edging, aerating, digging, scarifying, pets or garden work.
- Look for visible damage close to the charging station where cables are frequently moved.
- If a repair connector is suspect, remake it with a connector suitable for buried boundary wire rather than twisting bare conductors together.
3. How to narrow down a boundary-wire break
Husqvarna’s wire-break procedure uses the charging station connections and guide wire to help isolate which section of the boundary loop is damaged. This can reduce the amount of lawn you need to inspect. Follow the manufacturer procedure for your installation and mower model before changing station connections.
Typical clues: the fault started immediately after garden work; the LED changed from green to flashing blue; a connector is loose; or the mower worked normally until a specific area of cable was disturbed.
4. Check ECO mode before digging up the lawn
With ECO mode active, loop and guide signals are switched off while the mower is parked. A flashing green station LED can therefore be normal ECO-mode behaviour. Follow the mower’s ECO-mode start procedure before treating this as a wire break.
5. What if the station LED is green but the mower still says No Loop Signal?
A green station indication makes a simple open boundary loop less likely. Confirm the exact model, installation type and whether anything changed before the error appeared. Some model/service situations may require the loop signal to be re-established or mower-side diagnosis. If the installation tests normally but the error remains, use model-specific diagnostics or a Husqvarna dealer rather than replacing parts at random.
6. Wire installation or EPOS?
This guide is primarily for Automower installations that use a physical boundary wire. NERA/EPOS installations use virtual boundaries and positioning technology, although some configurations can also use support-by-wire. If your mower is running EPOS, select the exact model and installation type in MowerFixAI so you do not follow the wrong fault path.
When should you book a repair?
- The loop tests and connections appear correct but the error persists.
- The charging station shows a red fault state.
- There is visible damage to sealed electronics, the station board or power system.
- The mower has suffered lightning, water ingress or impact damage.
- You are not comfortable testing or repairing buried low-voltage wiring.
Diagnose your exact Automower
Select the exact Husqvarna model and symptom so MowerFixAI can separate boundary-wire, charging-station, mower and EPOS-related causes.
Diagnose My MowerFind a DealerFind PartsRelated MowerFixAI guides
Manufacturer references
MowerFixAI is independent of Husqvarna. Model-specific safety instructions and official procedures take priority.